This universal dual battery bank voltage display may be installed in any 12/24V system (negative ground only)

Dual Bar Graph Voltage Display Wires Directly To Battery

INDICATOR INSTALLATION

1. Locate Indicator in a convenient place on the vehicle.

2. Place the template in position and center punch in 4 places.

3. Drill holes as shown.

4. Cut out square hole.

5. Connect wiring to batteries in accordance with the wiring diagram

6. Install as shown.

7. Insert (4) #8-32 screws supplied and tighten. (CAUTION: Do not over tighten because you will bend the plastic bezel and break the watertight seal).