Kussmaul Single Battery Bank Voltage Display
This Universal Single Battery Bank Voltage Display may be installed in any 12/24V system
1. Locate Indicator in a convenient place on the vehicle.
2. Place the template in position and center punch in 4 places.
3. Drill holes as shown.
4. Cut out square hole.
5. Connect wiring to charger using butt connector supplied.
6. Install as shown.
7. Insert (4) #8-32 screws supplied and tighten, (CAUTION: Do not over tighten because you will bend the plastic bezel and break the watertight seal ).